Intended Use; Assembly And Operation - KRESS KUS10P Manual De Instrucciones

used for comparing one tool with another;
– The declared vibration total value may also be used in
a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the auxiliary handle
Warning! Always use the auxiliary
handle when operating the
machine.
Assembling the grinding/cutting disc
Adjusting the outer flange clamping
Adjusting the wheel guard
Note: Before any work on the
machine itself, pull the mains
plug. For work with grinding or
cutting discs, the wheel guard
must be mounted.
Place the guard in the groove on
the spindle collar and rotates to the
required working position. Clamp the
guard with the screw. The grinding disc
must be rotate freely within the guard.
The closed side of the wheel
guard must always point to the
operator.
OPERATON
Using On/Off Switch
Hand Grip Areas
Rough Grinding
Warning! Never use a
cutting disc for roughing.
Cutting
Warning! For cutting metal,
always work with the wheel
guard for cutting.
Auto-Stop Carbon Brushes
Note: When the resin insulating tip
(11) inside the carbon brush (12) is
exposed to contact the commutator
(10), it will automatically shut off the
motor. When this occurs, both carbon
brushes should be replaced. Keep the
carbon brushes clean and free to slip
in the holders. Both carbon brushes
should be replaced at the same time.
Use only identical carbon brushes.
Cleaning The Air Filter Regularly
Note: The air filter needs to be
cleaned after using the machine for
a while.
WORKING HINTS FOR
YOUR ANGLE GRINDER
If your power tool becomes too hot, run no load for
FIGURE
2-3 minutes to cool the motor.
Never start your angle grinder with the disc/ accessory
in contact with the workpiece.
Always start at no load to achieve maximum speed
then start working.
See Fig. A
Do not force the disc to work faster, reducing the
Disc's moving speed means longer working time.
When grinding, always work with a 15° to 30° angle
See Fig. B
between disc and workpiece. Larger angles will cut
ridges into the workpiece and affect the surface finish.
See Fig.
Move the angle grinder across and back and forth
C1, C2
over the workpiece.
When using a cutting disc never change the cutting
angle otherwise you will stall the disc and angle
See Fig. D
See Fig. E
See Fig. F
See Fig. G
9
EN
See Fig. H
See Fig. I