Worx WX700 Manual De Instrucciones página 13

6. TO USE THE GRINDER (See Fig. E)
ATTENTION: Do not switch the grinder
on whilst the disc is in contact with the
workpiece. Allow the disc to reach full speed
before starting to grind.
Hold your angle grinder with one hand on the
main handle and other hand firmly around the
auxiliary handle.
Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control, material removal and
minimum overloading, maintain an angle between
the disc and work surface of approximately 15
when grinding.
Use caution when working into corners as contact
with the intersecting surface may cause the grinder
to jump or twist.
When grinding is complete allow the workpiece to
cool. Do not touch the hot surface.
7. cUTTING
WARNING! For cutting metal,always
work with the wheel guard for cutting.
When cutting, do not press, tilt or oscillate the
machine. Work with moderate feed, adapted
to the material being cut.
Do not reduce the speed of running down
cutting discs by applying sideward pressure.
The direction in which the cutting is
performed is important.
The machine must always work in an up-
grinding motion. Therefore, never move the
machine in the other direction! Otherwise, the
danger exists of it being pushed uncontrolled
out of the cut.
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve
maximum speed then start working.
2. Do not force the disc to work faster,
reducing the Disc's moving speed means
longer working time.
3. Always work with a 15-30 angle between
disc and workpiece. Larger angles will
cut ridges into the workpiece and affect
Angle grinder
All manuals and user guides at all-guides.com
4. When using a cutting disc never change
5. When cutting very hard material best
6. When using a diamond disc it will become
-30
0 0
7. Always ensure the workpiece is firmly held
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
TROUBLESHOOTING
Although your new angle grinder is really
very simple to operate, if you do experience
problems, please check the following:
1. If your grinder will not operate check the
2. If your grinder wheel wobbles or vibrates,
the surface finish. Move the angle grinder
across and back and forth over the
workpiece.
the cutting angle otherwise you will stall
the disc and angle grinder motor or break
the disc. When cutting, only cut in the
opposite direction to the disc rotation. If
you cut in the same direction as the disc
rotation the disc may push itself out of the
cut slot.
results can be achieved with a diamond
disc.
very hot. If this happens you will see a full
ring of sparks around the rotating disc.
Stop cutting and allow to cool at no load
speed for 2-3 minutes.
or clamped to prevent movement.
power at the main plug.
13
EN