Installation Steps; Care And Cleaning - AVS Ventvisor Instrucciones De Instalación

Ocultar thumbs Ver también para Ventvisor:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation Steps

Place the visor in the window frame, beginning at the front, flexing it slightly to insert the rear end flange. The front end flange will insert
BETWEEN the rubber window channel and the mirror cap. Ensure the free ends are exposed.
mirror base
plate
3
front flange
Use an adjustable wrench to lossen (but do not remove) the bolts located on the inside face at the rear of the front door. Slip the rear end
flange BETWEEN the rubber window channel and the loosened trim panel. Retighten bolts.
adjustable
wrench
4
With the visor in its final position, remove the remaining tape liner
by pulling on free ends.
5

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
bolt
mirror base
plate
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
window guide
tape
window guide
Apply pressure along all flanges to ensure proper adhesion of tape.
Roll window back up and leave for 24 hrs for tape adhesive to cure.
6
Repeat Steps 1-6 for opposite side.
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
plastic molding
free end
visor in
position
Tabla de contenido
loading

Tabla de contenido