Weinmann VENTI-O2 Descripción Del Aparato Y Manual De Instrucciones página 14

4. Clean the creased tube thoroughly to remove all residues, using warm water
containing a little washing-up liquid. Thoroughly wash out the inside of the tube.
5. Rinse the creased tube thoroughly inside and out with clear warm water.
6. Thoroughly shake out the tube system.
7. Hang up the tube system and allow it to drip dry, in order to prevent moisture
entering your therapy device.
8. Use the therapy device to dry the tube system completely. For details see the
instructions for use for your therapy device.
Disinfect the housing
Clean the housing, connectors and connecting cable by simply wiping down with
disinfectant. We recommend TERRALIN for this purpose. You are recommended to
wear suitable gloves (e.g. household or disposable gloves) during disinfection
procedures. Observe the instructions for the disinfectant used.
Disinfect the tube system
As a disinfectant we recommend GIGASEPT FF. You are recommended to wear
suitable gloves (e.g. household or disposable gloves) during disinfection procedures.
Observe the instructions for the disinfectant used.
No disinfectant may penetrate the double tube.
To disinfect, proceed as follows:
Remove double tube:
Grey adapter
Double tube
Sleeve
Transparent adapter
Disinfect double tube
14
EN
Hygiene preparation
1. Release both sleeves from the adapters.
2. Pull the double tube out of the creased tube.
3. Take the short piece of the double tube off the gray
adapter. Then take the tube out of the transparent
adapter.
Sleeve
4. Release the long part of the double tube from the
transparent adapter.
1. Seal all four openings of the double tube using the
sealing plugs supplied.