6
Cleaning and maintenance
6.1 Maintenance
Before performing any maintenance
operation, isolate the hood from the
electrical supply by switching off
C
at the connector and removing the
connector fuse.
Or if the appliance has been con-
nected through a plug and socket,
then the plug must be removed from
the socket.
6.2 Cleaning
• The cooker hood should be cleaned regularly
(at least with the same frequency with which
you carry out maintenance of the fat filters)
internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do
not use abrasive products. DO NOT USE
ALCOHOL!
WARNING: Failure to carry out
A
the basic cleaning recommenda-
tions of the cooker hood and re-
placement of the filters may cause
fire risks.
• Therefore, we recommend oserving these
instructions.
• The manufacturer declines all responsibility for
any damage to the motor or any fire damage
linked to inappropriate maintenance or failure
to observe the above safety recommendations.
6.3 Grease Filter
Traps cooking grease particles.
This must be cleaned once a month using non
aggressive detergents, either by hand or in
the dishwasher, which must be set to a low
temperature and a short cycle. When washed in a
dishwasher, the grease filter may discolour slightly,
but this does not affect its filtering capacity.
Range Hood / User Manual
6.3.1 Remove grease filters
• To remove the filters, grasp the handle, push the
filter up and lift out.
6.3.2 İnstall grease filters
• Place filter drip trays into the rear of the hood.
• Insert the grease filter into opening and drop
into the trays.
6.4 Replacing the light bulb
Before replacing the lamps, switch
C
power off at service panel and
lock service panel disconnecting
means to prevent power from being
switched on accidentally.
Turn off the lights and fan. Allow the
C
lights to cool before handling. If new
lights do not operate be sure lights
are inserted correctly before calling
service.
17 / 59 EN