Troubleshooting - Home NetWerks 7148-01-AX Manual De Instrucciones

CARE AND CLEANING (Continued)
4. Join the connectors from the fan housing (A) to the grille (B). Attach
the grille (B) by pinching the mounting springs and inserting them
into the narrow rectangular slots in the fan housing (A).
Turn on the power source. Test the unit.

TROUBLESHOOTING

PROBLEM
The fan seems louder than
it should be.
The fan is not clearing the
humidity from the room.
The BLUETOOTH device
®
will not pair with the fan.
The switch will not power up.
The switch has power, but
the fan does not.
The wall switch does not
work with the bath fan.
POSSIBLE CAUSE
The CFM is too great for the space.
The damper is damaged or not working properly.
The bend in the duct is too close to the fan
discharge.
The fan discharge is reduced to fit a smaller duct.
The fan body is not attached securely.
There is insufficient airflow intake in the room.
There is insufficient CFM.
NOTE: Using a tissue is not the correct method for
determining if the fan is operating properly. If the fan
clears steam from the room within approximately
15 minutes of completing your shower, then the
fan is operating properly.
Another device is already paired.
There is a wiring issue at the switch, or the power
is not turned on at the fuse box or circuit breaker.
The grille is not receiving a signal from the switch.
The speaker and the smart device are not
connected to the same WiFi network.
Neutral wire connection from the switch to the fan
is not engaging.
Wall switch is not paired to the bath fan.
4
A
B
SOLUTION
Be sure the CFM rating on the fan matches the
square footage of your room.
Check the damper to ensure it is opening and
closing properly. If the damper has become
damaged, please call Customer Service.
Be sure you do not have any sharp bends in the
duct within 18 in. of the fan discharge.
Use the recommended size ducting to reduce fan
noise.
Be sure the fan is securely attached to the ceiling
joists.
Be sure a door or window is slightly ajar or open to
allow airflow. The fan is not able to draw air out of
the room without enough airflow.
Be sure the CFM rating of the fan matches the
square footage of your room.
Make sure BLUETOOTH
other devices.
Check the wiring diagram on page 5 and confirm
wiring is correct. Verify the power is turned on.
Turn off power. Disconnect the grille for 5 seconds,
then reconnect the grille and test. Repeat as
necessary.
Long press the (
enable the switch pairing process.
Ensure your smart device is connected to the
same WiFi network that the speaker was
configured to.
Run a dedicated neutral wire from the switch to the
fan. Consult an electrician if necessary.
Press the (
seconds to initiate the switch pairing process.
12
5-hole
3-hole
4-hole
signal is turned off on
®
) button for 8 seconds to
) button on the wall switch for 5
Homewerks.com