Selection Of Installation Equipment - Svan SVV6374 Manual De Instrucciones

E1
Error Code for Induction hob
Problem
E1
E2/E3
E4/E5/E6
E7
E8/E9
E0
EE
The above are the judgment and inspection of common failures.
ATTENTION! To avoid danger, please do not disassemble the unit by yourself!
9.
Installation
9.1

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5cm space shall be preserved
around the hole. Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant and insulated work surface material (Wood and similar fibrous or
hygroscopic material shall not be used as work surface material unless impregnated) to
avoid the electrical shock and larger deformation caused by the heat radiation from the
hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of
the worktop should be at least 3mm.
L(mm)
SVV6374 590
SVI201 290
SVI6393B 590
SVI6391B 590
SVI632B2 590
SVI623FZ 590
Open circuit failure of
thermocouple
Possible causes
Signal lost (PCB failure)
Abnormal high/Low input
voltage
Thermistor failure.
Abnormal high
temperature (dry
burning)
Failure of IGBT sensor
IGBT Overheat
Display PCB failaure.
W(mm) H(mm)
520
520
520
520
520
520
Please contact after sales service.
What to do
Please contact after sales service.
Stop cooking and wait until input voltage back to
normal. If not please contact service center.
Please contact service center to repair.
Cut off power, wait for 30min and switch on.
If still not working, please contact service.
Please contact service center to repair.
Check if the fan is still working. If not please
contact service center to repair.
Please contact service center.
D(mm)
50 46
50 46
62 46
62 46
62 46
62 58
A(mm) B(mm)
560 490
270 490
560 490
560 490
560 490
560 490
X(mm)
50 min.
50 min.
50 min.
50 min.
50 min.
50 min.