Installation; Commissioning And Operation - Blumfeldt Heat Meister Manual Del Usuario

INSTALLATION

• The unit must be installed at least 2 meters above the floor and 1 meter
from the side wall.
• Drill two holes in the ceiling or wall, observing the sizes and distances
indicated in the illustration. Insert an M6 screw (5) through the ceiling
bracket (2) and fix it with a washer (12) and M6 nut (8).
• Insert the ceiling bracket (2) with expansion bolt (1) into the holes. Use a
spanner to securely fix the expansion bolts clockwise in the holes. Fix the
carabiner (14) of the M4 chain (15) to the suspension device (10).
• Fix the other carabiner to the cord clip (6). Pull the cord clip (6) through
the hole in the ceiling cover (3) and pull the power cord (9) through the
hole in the ceiling cover (3).
• Attach the carabiner (14) to the cord clip (6) by the M6 screw (5). Then fix
the ceiling cover (3) to the ceiling bracket (2) with the M4*6 screw (4).

COMMISSIONING AND OPERATION

• Insert the power plug into the socket. Make sure that the voltage of the
power outlet corresponds to the voltage indicated on the rating plate of
the device.
• Press the main switch on the top of the heater. The „-" mark will flash on
the digital display, indicating that the heater is now in standby mode.
• Press the MODE button on the control panel or remote control to switch
the heater on or to set a higher power level.
• Power levels 1, 2, and 3 are shown on the digital display.
• Press the TIMER button on the control panel or remote control to set the
timer to 0-9 hours. „0" means the timer is off.
• The power level and the timer are displayed alternately in the following
cycle: power level 10 seconds, timer 5 seconds.
• Press the LOUDSPEAKER button on the control panel or remote control
to turn the BT speaker on/off. Press the LIGHT button on the control panel
or remote control to turn the LED light on/off.
• Press the OFF button on the control panel or remote control to put the
unit in standby mode. The „-" symbol will flash again on the digital display.
• Press the main switch on the top of the heater to switch it off completely.
EN
13