Autoquip P-25-005 Manual De Instalación, Operación Y Servicio página 26

i DANGER
Do NOT used compressed air to push piston out of cylinder.
1. Remove the Spirolox ring from rod guide.
2. Drive rod guide back into ram using a soft hammer.
3. After rod guide has passed wire lock ring, remove ring from groove in cylinder.
4. After rings are removed, pull the whole rod assembly out of the cylinder.
5. Remove lock nut from base of rod.
6. Remove piston.
7. Inspect cylinder components for wear or damage. Replace parts as necessary. Specify the
cylinder model number stamped on the base of the cylinder when ordering parts.
6.3.1.3. Assemble Cylinder – Style 'A'
1. Position piston on threaded rod. Verify static O-ring is in place between piston and rod.
2. Install self locking nut on rod. Tighten nut.
3. Install all seals and wear strips on piston and rod guide.
4. Lubricate cylinder, piston, and rod guide with hydraulic fluid.
5. Position the piston assembly down, rod up and slide rod guide over the rod down to piston.
6. Drop piston and guide down into cylinder.
7. Insert lock wire in cylinder groove.
8. Force rod guide up against lock wire with compressed air inserted into guide breather vent.
9. Install Spirolox ring in top groove, after guide is in place.
26