Electrical Supply - Delabie BINOPTIC Manual De Instrucciones

OPERATION
Opens and closes automatically via infrared presence detection of the hands.
The electronic soap dispenser is compatible with:
• Vegetable-based liquid soap with a maximum viscosity of 3,000 mPa.s.
• Dedicated foam soap: cf. INSTALLATION section > Switch to foam soap mode.
• Hydroalcoholic gel (DELABIE dispensers without tanks type 512111, 512121, 512131, 512151
are not compatible).

ELECTRICAL SUPPLY

• Electrical supply: 100-240V/50-60Hz class II SELV (without earth connection).
• The installation must comply with current regulations in your country
• If the power supply cable is damaged, it must be replaced by the installer.
• Make sure the cables are secured in place by clamps or a rigid sheath.
INSTALLATION
Sections 1, 2, 3: Installing the spout
To prevent interference from infrared rays, do not install a reflective object in the sensor's detection zone.
• Cross wall models cf. pages 18-19 and wall-mounted models cf. pages 20-21: install the dispenser
at least 165mm above the washbasin.
• Deck-mounted models cf. pages 22-23.
Section 4: Installing the housing (pages 24-25)
Do not install the housing above the level of the spout (Fig. J page 24).
Section 5: Priming the pump (page 25)
Press and hold the button a (Fig. S):
• If the soap comes out of the spout in less than 10 seconds, release the button a (Fig. S) to stop
it priming.
• If the soap does not come out of the spout after 10 seconds of pressing the button, release the button
a (Fig. S). Priming will continue. Once the soap comes out of the spout, press the button a (Fig. S)
again or wave a hand in front of the sensor to stop it priming.
Section 6: Switch to foam soap (page 26)
• Remove the jumper located inside the housing cover (Fig. V) and place it on the pins in the box using
a pair of pliers (Fig. W)
• Change the diffuser for the one in the box (Fig. Y to AA)
Only use dedicated foam soap.
Section 7: Removing the tank (Fig. AB page 26).
4
EN