Lorell Península LLR60125 Instrucciones De Montaje página 5

ASSEMBLY INSTRUCTIONS
4
1
1
Step 1
Lay all surfaces on a non-abrasive surface with the holes facing up.
On the Table Top (A) insert 6 each Wood Dowels (4) in the holes shown on the drawing. Tap securely into
position with a Rubber Mallet or Hammer.
On the Table Top (A) insert 6 each Cam Screws (1) with a Phillips Screw Driver in the hole position shown on
the drawing.
On the End Panel (B) insert 2 each Wood Dowels (4) in the hole position shown on the drawing. Tap securely
into position with a Hammer or Rubber Mallet.
On the End Panel (B) insert 3 each Cam Screws (1) with a Phillips Screw Driver in the hole position shown on
the drawing.
On the End Panel (B) insert 2 each Cam Lock (2) in the hole positions shown on the drawing. When inserting
the cam lock make sure that the arrow is facing toward the cam screw entry.
On the Large Support Panel (C) insert 4 each Cam Lock (2) in the hole position shown on the drawing. When
inserting the cam lock make sure that the arrow is facing toward the cam screw entry.
On the Small End Panel (D) insert 2 each Wood Dowel (4) in the hole position shown on the drawing. Tap
securely into place with a Rubber Mallet or Hammer.
On the Small End Panel (D) insert 3 each Cam Screw (1) in the hole position shown on the drawing with a
Phillips Screw Driver.
On the Small End Panel (D) insert 2 each Cam Lock (2) in the hole position shown on the drawing. When
inserting the cam lock make sure that the arrow is facing toward the cam screw entry.
On the Small Support Panel (E) insert 4 each Cam Lock (2) in the hole position shown on the drawing. When
inserting the cam lock make sure that the arrow is facing toward the cam screw entry.
LLR60125_87301_Manual.indd 4 LLR60125_87301_Manual.indd 4
4
1
1
4
A
Table Top
1
4
4
D
Small End Panel
2
1 4
4
B
End Panel
2
2
E
Small Support Panel
2
C
Large Support Panel
Page 4 of 18
3/7/11 10:09 AM 3/7/11 10:09 AM