Idiomas disponibles
Idiomas disponibles
English
Important
• Read the instructions carefully in
conjunction with the illustrations before
using the appliance.
• Avoid damage. Before connecting please
check if the voltage indicated on the
appliance corresponds to the mains
voltage in your home (110-127 V,
220-230V or 240 V).
• Do not use the appliance when the mains
cord, the plug or other components are
damaged. If the mains cord of this
appliance is damaged, it must only be
replaced by Philips or their service
representative, as special tools and/or
parts are required.
• The blades are sharp! Do not hold the
blades. Remove the mains plug from the
wall socket before attaching or removing
the bar blender accessory. Keep the
appliance away from children.
• Do not lay down or hang the appliance
where it can fall or be pulled into water
(tub, sink). However, if the appliance has
accidentally fallen into water: do not
touch it! Unplug immediately.
• Always fix the beaters or the bar blender
accessory on to the mixer before you
connect it to the mains.
• Lower the beaters or the bar blender
accessory into the ingredients before
switching on.
• Use the high-shaped mixing beaker
provided, filled no higher than 2/3 of its
maximum contents, to prevent spatting
and spillage.
• Never immerse or rinse the main unit in
water.
General description
(fig. 1)
A
Safety switch
B
Speed selector
I = Low speed, I I = High speed
C
Motor unit
D
Bar blender attachment
E
Bar blender blades
F
Beaters coupler
G
Beaters release button
H
Beaters
I
Wall holder with screws and rawlplugs
J
Cord storage
K
Mixing beaker
All manuals and user guides at all-guides.com
4
Making ready for use
Bar blender
- Screw the bar blender attachment in the
direction of the arrow until tight (fig. 2). (To
remove: screw in opposite direction.)
Beaters
- Insert the beaters in the holes of the coupler
and press to fix ("Click!") (fig. 3).
- Screw the coupler in the direction of the arrow
until tight (fig. 4). (To remove: screw in
opposite direction.)
Switching on/off
- Put the ingredients into the mixing beaker
provided.
- Put the ingredients in a bowl.
- Insert the mains plug into a wall socket.
- First lower the beaters or blades into the
ingredients.
- Then switch the motor on:
Push upwards and hold the safety switch with
the thumb of your free hand (fig. 5).
Set the speed selector to the required position
with the index finger of the hand with which you
are holding the appliance (fig. 6).
• Once the appliance is switched on you need
only to keep the speed selector pressed in.
• If you wish to change speed during operation,
slide your finger over the speed selector.
Ensure to keep the speed selector pressed in,
because otherwise you will have to push the
safety switch upwards again.
• When the appliance is switched off the safety
switch is reset automatically.
- To switch off simply release the speed selector
(fig. 7).
Tips
• Beaters.
Use the beaters for mixing batters (for (thin)
pancakes, wafers, biscuits, cake, puff pastry,
etc.), creams, toppings, instant pudding, egg
white or whole egg, mayonnaise, sauces and
soups, for puréeing potatoes and for whipping
double cream.
Select speed I first and then if possible switch
over to speed I I to prevent splashing. For airy
whipping (especially egg white) use speed I I .
For small quantities you can also fix only one
beater and mix in e.g. a drinking glass.
