Fan Assembly. Pgs - Craftmade Ellington E-KM52ABZ5LKRCI Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 10in. downrod provided to use with an
extended downrod (sold separately). [If you wish
to use the 10in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball and remove the pin and clip.
Lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and
slide it down the longer downrod, B (the top of
the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from downrod (if
you have not already done so). Slide downrod
through canopy, rod support cap, rod support
(loosen rod support set screw to prevent
scratching the downrod finish) and then the
yoke cover.
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke
and re-insert pin and clip that were previously
removed. Tighten yoke set screws and nut
securely. Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
clip
A
electrical wiring
canopy
rod support cap
rod support
clip
page 4
set screw hole
pin
hanging ball
pin
B
downrod
rod support
set screw
yoke cover
yoke set screw
pin
motor
housing