DANGER
WHAT TO DO IF THE SMELL OF GAS IS PRESENT:
– DO NOT attempt to light the heater.
– Extinguish any open flame.
– Shut off gas to heater.
– If odor continues, contact your local gas
supplier or fire department.
– DO NOT touch or use any electric switch or
any electric device that can cause a spark.
– Immediately call your gas supplier from a
neighbors phone. Follow the gas suppliers
instructions.
– If you can not reach your gas supplier, call
the fire department.
– Service must be done by a qualified
service agency.
WARNING
NEVER store or use gasoline or other flammable
vapors and liquids in the vicinity of this heater.
NEVER store a propane (LP) cylinder not
connected to this heater in the vicinity of this heater.
NEVER connect heater to an unregulated gas supply.
NEVER obstruct the flow of combustion and
ventilation air.
NEVER use duct work in front or rear of heater.
NEVER modify this heater or operate a heater that
has been modified.
NEVER service, move or handle heater while still
hot or operating
Keep all combustible materials away from this heater.
Minimum Clearance From Combustibles
Front
72 in.
WARNING
NOT TOUCH. KEEP CHILDREN, ANIMALS,
CLOTHING AND COMBUSTIBLES AWAY
FROM HEATER.
© 2017, Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, CONNECTED
TO A POWER SOURCE, OR WHILE CONNECTED TO A FUEL SOURCE
Safety Information
PROPANE IS AN
EXPLOSIVE GAS.
RISK OF BURNS,
FIRE AND
EXPLOSION!
Sides
Top
12 in.
24 in.
CAUTION!
HOT WHILE IN
OPERATION. DO
WARNING
– ALWAYS install the heater so that it is not directly
exposed to water spray, rain, dripping water, or
wind.
– Use heater in accordance with all local codes
and with CSA 5.90 U.S. (5th Ed.) Infrared
Patio Heater.
– This heater is shipped from the factory
for use with propane (LP) gas only. Do not
convert to any other gas. Installation must
conform to local codes, or in their absence,
with the standard for the Storage and
Handling of Liquefied Petroleum Gases ANSI/
NFPA 58 and the Natural Gas and Propane
Installation Code CSA B149.1.
– Gas supply connections should be checked
by using a 50/50 soap and water solution.
Never use a flame to check for gas leaks.
– Use only the regulator and hose assembly
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
– This heater is not for use on finished floors.
Minimum and Maximum Inlet
Model
Min.
Max.
WARNING
material and contact with hot surfaces both
during use and while in storage.
2
For use with
propane (LP) gas
only.
Pressure
18-PCH-O
5 PSI
Bottle Pressure
The hose assembly
shall be pro tected
from traffic, building
Cabinet Heater User's Manual