Holiday Mode; Storing The Remote Controls; Memorising 2 Or 4-Button Remote Controls; Memorising 3-Button Remote Controls - SOMFY ROLLIXO RTS Manual De Instalación

Rollixo RTS
> Modification of the automatic closure time delay
The automatic closure time delay can be adjusted from 5 seconds to 2 minutes
(20 seconds by default)
To modify the automatic closure time delay, one or other of the automatic
closure options must be activated.
[1]. Run the timer by pressing and holding down the T button for 2 seconds.
Indicator light
[2].
is obtained.
Indicator light
[1]
2s
5 s ... 2 min
[2]

8.3 Holiday mode

> Activating/deactivating holiday mode
The door must be closed to activate this mode.
To activate/deactivate holiday mode, press button
1 2 3 4
Prog
STOP
When holiday mode is active, each time a locked control (programming
interface or remote control) is pressed, indicator lights 1, 2, 4 and Prog start
> Holiday mode parameter setting
ON OFF
X (by
default)
Dipswitch 5
Holiday mode
X
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
until the 4 indicator lights
STOP
1 2 3 4
Prog
STOP
Comments
Programming Interface locked
(remote controls and keyswitch
active)
Remote controls locked (programming
interface and keyswitch active)

9 - STORING THE REMOTE CONTROLS

9.1 Memorising 2 or 4-button remote controls

[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press a button on the remote control to be memorised within a maximum
time delay of 2 minutes.
The indicator light above button
control is memorised in the receiver.
[1]
Prog
Prog

9.2 Memorising 3-button remote controls

[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the PROG button on the back of the remote control to be memorised
within a maximum of 2 minutes.
The indicator light above button
control is memorised in the receiver.
[1]
Prog Prog
9.3 Memorising by copying a previously memorised
remote control
This operation must be carried out close to the receiver.
A = "source" remote control already stored
B = "target" remote control to be stored
> With an RTS Keygo
A
> With a 3-button remote control
A
2s
Prog
[2]
Prog
Prog
[2]
Prog
A
B
2s
B
< 1s
11