Special Safety Instructions - Monti Bristle Blaster Manual De Instrucciones

Operating instructions
GB/US
5.3

Special safety instructions

1. Prior to operating the tool, always check for faulty and defective parts or any other conditions that might affect
the operativeness. Never use tool if damaged or adjusted incorrectly. Any damaged safety features, starter
lever or other faulty parts are to be repaired or replaced by an authorised service engineer, provided there are
no other instructions in this manual. Never use tool with faulty starter lever.
2. User screw clamps or a vice to secure the workpieces to be machined. Always use both hands to operate the
tool.
3. Only use tool with genuine accessories such as the Adaptor System and Bristle
®
Blaster Belt. The Bristle Blaster
®
Blaster Pneumatic and is therefore not to be used in conjunction with other
accessories or other machines.
4. After replacement of the Bristle Blaster
5. Never operate compressed air tool with an operating pressure of more than 90 psi (6.2 bar) flow pressure
at the compressed connection to the tool. This tool is not speed-regulated. The speed will increase with an
increase in the air pressure above 90 psi (6.2 bar). The operating pressure for this tool must be regulated
within the operating range specified by a reliable automatic compressed air regulator (23 mm compressed air
regulator silver, 11 mm compressed air regulator blue), see section 6, Compressed air supply.
6. Check compressed air at regular intervals. To ensure the compressed air is clean and oiled, if necessary
integrate a service unit into the compressed air line.
7. When the tool is put down on a work table or on the floor, the sign always must point upwards.
8. If the tool is not in use, disconnect from the compressed air supply and store in a suitable place to prevent
unintentional or unauthorised use in the absence of an authorised individual.
9. In use, always hold by the tool body and the vertical handle.
®
10. Bristle Blaster Belt in the correct operating direction.
®
11. The Bristle Blaster
12. Never carry the tool holding it at the pneumatic hose. Protect compressed air hose against heat, sharp edges
and running over. (If necessary use a hose burst safety valve).
13. If the tool suddenly feels different (level of vibration) or produces a different noise (pitch), the tool should be
shut down immediately and the accessories such as the Adaptor System, Bristle Blaster
damage.
16
®
®
Belt, check Adaptor System for correct assembly.
Belt can produce sparks on machining hard surfaces.
Belt is specially designed for use on the Bristle
®
Bristle Blaster Pneumatic
®
Belt checked for