Idiomas disponibles
Idiomas disponibles
EN ZPIR-8000 MOTION SENSOR
COMPATIBILITY
The sensor works with the Z1 ZigBee Bridge and the ICS-2000.
1. (RE)PLACE THE BATTERIES
A
Remove the battery cover from the sensor.
B
Place 2x AAA batteries (not included) in the sensor. Note the positive and
negative polarity in the compartment. Close the battery cover.
2. INDICATORS
The sensor contains a LED indicator (This is not a button) to show the status
of the sensor. Please see below the meaning of the different LED indications.
LED FUNCTION TABLE
Connection mode
Connected successfully
Sensor reset
Sensor triggered (When motion
is detected)
4
LED will flash once per second for
approximately 1 min. (After 1 min
the LED will stop flashing)
LED will stop flashing (The App will
also indicate when the connection
is successful)
LED will flash fast (for 2 seconds)
LED will flash once
3. DOWNLOAD APP
To connect the sensor with a Z1
ZigBee bridge or ICS-2000, first get
the App by scanning the QR code or
go to trust.com/zigbee and install it.
4. CONNECT SENSOR
A
In the App, select a room,
press the + button and follow
instructions.
For manual set up of push-
notifications go to the rules tab,
press the + button and select
notification wizard.
5. MOUNT THE SENSOR
A
Mount the arm of the sensor on a
flat surface and secure it with the
included screws.
B
1. Place the sensor on the
mounting arm.
2. Secure the sensor by pulling it
down on the mounting arm.
ZPIR-8000 MOTION SENSOR EN
RESET SENSOR AND
ACTIVATE CONNECT MODE
Warning: This step will remove
the sensor from the Z1 ZigBee Bridge
or the ICS-2000 . To reset the sensor
press the button in the hole at the
side of the sensor for approximately
5 sec with the included pin. The LED
will flash fast to confirm the reset.
Activate connect mode: After
resetting the sensor you can activate
the connect mode by pressing the
button for approx. 1 sec. The LED
will flash for 1 minute to indicate the
connection mode.
The wireless range increases when
you add more ZigBee products (me-
shing). To learn more about meshing
go to trust.com/zigbee
5
