PULOX PO-650B Manual De Instrucciones página 33

parameter to be adjusted, then press the "left button" or
"right button" to change data. Each press of the "left button"
or "right button", the data will raise or descend for one time
accordingly.
If the alarm function is on, the device will provide medium
priority alarm signal when the data of SpO
beyond the limit.Intermittent alarm will occur and the
measure value becomes yellow.
Medium priority indicating that prompt operator response is
required.
2. Alarm state setting
Press the "up button" or "down button" to select "Alarm",
then choose the alarm state (on/off) by pressing the "left
button" or "right button".Choose "on" to turn on the alarm,
and choose "off" to turn off the alarm for good.
3. Exit the alarm settings
Press the "menu button" to exit the Alarm Settings Menu.
b. Pulse sound indication setting
In the main menu interface, press the "up button" or "down button"
to select "Pulse Sound", then press the "left button" or "right button"
to choose to have the Pulse Sound (heart beat)"on" or "off ".
c. Backlight adjustment
In the main menu interface, press the "up button" or "down button"
to select "Brightness", then press the "left button" or "right button"
to change the number in order to adjust the brightness of screen.
d. Data storage setting
This device has the ability to store 24 hours data value.It can store
the measured pulse rate and SpO
to the computer, display the data and print reports (with the
included SpO Software - Green Heart)
2
1. In the main menu interface, press the "up button" or "down
button" to select "Record", then press the "left button" or
"right button" again to enter the dialog box of Figure 11 or
finger 12.If it is not in recording state, will come into Figure 11;
if it is in recording state, will come into Figure 12.
value accurately, transfer the data
2
or pulse rate is
2
EN