Tabla de contenido
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
Pneumatic sandblaster
2
Air nipple
3
Trigger lever
4
Collecting bag for sandblasting material
5
Screw clamp
6
Blasting nozzle
7
Rotary control (1/0)
FILLING BLASTING MATERIAL TANK
Attention: Before opening the screw cap (9) on the blasting material tank (8) or changing any other
settings, the device must be completely depressurised and the sandblaster must be disconnected
from the compressed air supply.
Note: Only use compatible blasting material (14) for your sandblasting work. The maximum grit size is
0.8 mm. We recommended using blasting material with no risk of silicosis (ground blast furnace slag)
with a grit size of 0.2 mm to 0.8 mm.
1. Ensure that the blasting material (14) is absolutely dry and not too coarse-grained.
2. Open the screw cap (9) on the blasting material tank (8) by turning the cap counterclockwise.
3. Fill the desired quantity of blasting material (14) into the blasting material tank (8).
4. Take care, do not overfill the tank, the maximum tank capacity is 900 ml.
5. Replace and close the screw cap (9) on the blasting material tank (8) by turning it clockwise.
6. Ensure that the screw cap is properly seated and tightly closed.
BLASTING MATERIAL GRIT SIZE
The larger/coarser the grit size of the blasting material used, the less precise the dirt removal process.
The blasting material included is small and is very suitable for the removal of rust bloom or soiling.
Finer blasting material is also gentler on the surface of the material and abrasion is confined to the
surface. For larger areas of rust, coarser blasting material should be used, which can be purchased
from larger stockists. Attention: Do not exceed the maximum grit.
1. Fitting the collecting bag for sandblasting material.
2. Using a screwdriver, attach the collecting bag (4) to the device with the screw clamp (5) included
in the package contents.
SELECTING AND FITTING ATTACHMENT
Select the accessories (10/11/12/13) that are best for the job being done.
Fit your chosen attachment firmly to the blasting nozzle (6), taking care to ensure that no air can
escape at the sides.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
8
9
10
11
12
13
14
Tel.: 02196 720480
Fax.: 02196 7204820
Blasting material tank
Screw cap
Wide-angle attachment
Spot attachment
Outer edge attachment
Inner edge attachment
Blasting material
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
