Steren COM-817 Manual De Instrucciones página 66

4.3.1 WPS Settings
- WPS Status: You can use this function to setup the wireless connection
between this repeater and wireless network card. The default is Enable.
- AP PIN Code: This code is to identify de wireless device.
- Add A New Device: Add a new device by WPS.
4.3.2 Add a New Device
- Enter the new device's PIN: This code may be marked in the new wireless
device.
- Press the button of the new device in two minutes: New device will send
a PIN code to wireless repeater.
WPS can connect the wireless adapter and the repeater in a safe way. If
you have a wireless network card which has WPS button, you may set up
a safe network via the following methods.
Method 1:
1. Push the WPS button in the Repeater until the SYS LED is flashing
yellow.
2. Push the WPS button in the wireless network card for about 3-5seconds.
3. The safe connection will be established automatically.
Method 2:
1. Input the PIN code of the adapter's WPS page into the repeater's WPS
configure page, then click 'connect'.
2. Push the 'PIN Input Config (PIN)' in the Wi-Fi protect setup of the adapter
3. Select the repeater in the pop-up window, then click 'Select'
4. The connection between the adapter and the repeater will be established
automatically.
21 21