Performing Transmission Output Changeover Switch Settings - Toa WM-D5200 Manual De Instrucciones

8.4. performing transmission output changeover switch settings

Transmission can be set for either of two outputs: 'H' (10 mW) or 'L' (1 mW).
The switch is factory-preset to the 'H' position.
note
Be sure to turn the microphone's power switch OFF before performing settings.
step 1. Confirm that the power switch is turned OFF, then remove
the battery compartment cover and battery.
step 2. Using the supplied screwdriver, set the changeover
switch to the desired transmission output.
Set the switch to the 'H' position when using the
microphone in a wide area.
If the same bank and channel are used in close proximity
in adjacent locations, set the switch to the 'L' position
to shorten the radio wave transmission range for each
location to minimize interference.
step 3. Reinsert the battery and securely replace the battery compartment cover.
1
Transmission output changeover switch
H L
1
Screwdriver
(accessory)
2
15