Performing Encryption Settings - Toa WM-D5200 Manual De Instrucciones

8.2. performing encryption settings

To enhance security, the WM-D5200 is provided with an encryption setting function that prevents
leakage of transmitted information.
This function also has the advantage of eliminating radio interference if enabled. Before enabling
the encryption setting, be sure that bank and channel settings are completed first.
tip
In addition to the WM-D5200, the WT-D5800 Digital Wireless Receiver also requires setup.
Therefore, be sure to see the receiver's instruction manual as well.
8.2.1. encryption settings summary
[Before use (preparatory operation for setting)]
Transmit an ID number from the wireless microphone to the receiver. The ID number is randomly
selected on the wireless microphone side. The ID number to be used is selected from an extensive
number of combinations and cannot be designated by the operator, nor can it be identified from
outside.
[in use] (no operations required.)
When the receiver detects a signal from the wireless microphone, it simultaneously reads the
microphone's ID information, ensuring that only the audio of the wireless microphone assigned
with the same ID number as the receiver can be output. Even if the bank/channel numbers are
identically set in an attempt to enable reception of a radio signal from outside, since no audio is
output if the ID number does not match, the possibility of leakage of transmitted information to the
outside is quite low.
[encryption setting on/oFF confirmation]
step 1. After removing the battery compartment cover, switch ON the microphone power switch.
step 2. Confirm the status of the Encryption indicator.
The setting is ON when the indicator is lit, and OFF when the indicator is unlit.
note:
The encryption setting is factory-preset to OFF
1
2
Encryption indicator
Encryption setting switch
11