Install The Batteries; Handset Battery - Cidco Communications D936 Manual Del Usuario

D936-937.book Page 2 Friday, August 30, 2002 10:24 AM
D936/D937 - 900MHz Cordless
120V WALL
OUTLET
AC ADAPTER
TELEPHONE
WALL OUTLET
DC9V
JACK
LONG LINE
CORD
b. Thread the cord through the clip on the base to
prevent the cord from pulling loose.
I B
NSTALL THE ATTERIES
Use this procedure to install or replace the battery in the
handset. Be sure to follow the battery specifications and
safety instructions. See "SAFETY INSTRUCTIONS" on page
iv.
CAUTION
To reduce the risk of fire, use only 3.6V 850mAh
Nickel Cadmium (NiCad) battery pack in this phone. Do
not attempt to open the sealed battery pack. All used
Ni-Cad batteries must be recycled or disposed of
properly in accordance with all applicable laws.
2 INSTALLING THE D936/D937
H
ANDSET
a. Press down on the battery cover and slide the cover
BASE
down to expose the battery compartment.
b. Locate the battery "+" and "-" signs inside the battery
compartment and the corresponding "+" and "-" on
the battery pack. Align the battery pack "+" and "-"
with the "+" and "-" in the battery compartment and
press down.
c. To replace the battery cover, slide the cover upwards
TEL Line
until the tab engages and the cover snaps into
JACK
place.
NEED TO KNOW
Prior to first use, place the handset (display side up) in
the base and charge the battery for at least 12 hours
before connecting the telephone line. The charge light
on the base comes on and indicates that the handset is
charging. The handset must be properly placed in the
base, display side up, in order for the handset battery
to charge.
B
ATTERY