Luminance Brands Kathy Ireland Home LOFT CF765BQ01 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.3
Route the Two 80" Motor Wires through the center hole
in the Motor Cover .
Place the Motor Cover over the Motor by aligning the
Reverse Switch Hole in the Cover over the Reverse
Switch, as shown in Figure 3 .
Secure by installing Three #10-24 x 10mm Pan Head
Screws with Lockwashers (supplied) (Figure 3) .
3.4
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the Downrod (Figure 4) .
Remove the Pin from the Downrod, then remove the
Hanger Ball (Figure 4) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .10 .
NOTE: Do not loosen the Screw holding the Green
Ground Wire.
(Continued)
#10-24 x 10mm PAN
HEAD SCREW WITH
LOCKWASHER (3)
MOTOR COVER
MOTOR COVER
REVERSE SWITCH
HOLE
REVERSE
SWITCH
Figure 3
PIN
GREEN GROUND WIRE SCREW
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 4
6
GREEN GROUND WIRE
6" DOWNROD
HANGER BALL
U.L. Model No.: CF765-1