Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAUTION
• If you want to remove a large number of ice
cubes without removing the ice bucket, turn
off the ice maker, remove the ice maker's front
cover, and then carefully remove the ice cubes.
Replace the ice maker's front cover when you
are done. Note that the ice cubes in the ice
maker can spill out over the drawer.
• Do not put food in the ice bucket. If you store
food in the ice bucket, the food can strike the
ice maker when you open or close the door,
causing damage to the ice maker.
• Note that the ice cubes in the ice bucket may
spill out over the drawer when you remove the
ice bucket from the drawer.
If this occurs, be sure to pick up the ice cubes
that spilled out of the drawer.
• If a power failure occurs, ice cubes may melt
then freeze together when the power comes
back on, causing the dispenser to stop
working.
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
If you use all the ice at once, you must
repeat Steps 2 and 3 under Ice Making.
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
DA68-03030A-06.indb 26
Check the water level
Test button
English - 26
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket, lift up the bottom, and
then pull out. To put the bucket back in, push the
bucket straight back until you hear a click.
If you do not push the ice bucker firmly
into place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
CAUTION
• The inside of the ice bucket stays cold when it
is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with the
refrigerator.
• Have a suitably qualified person install and
connect the water supply line to the refrigerator.
• Connect the water supply line to a potable
water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
2016. 3. 31.
11:43
Tabla de contenido
