Notes:
•
In this mode, the air flow is selected automatically by the
appliance and cannot be set manually.
•
When operating in very cold rooms, the appliance defreezes
automatically, momentarily interrupting normal operation. In
this case, " Lt " appears on the display. During this operation, it
is normal for the noise made by the appliance to change.
•
In this mode, you may have to wait a few minutes before
the appliance starts giving out hot air.
Perfect!
•
In this mode, the fan may operate for short periods, even
though the set temperature has already been reached.
•
It may happen that the display shows "HL" alarm. In this
case, empty the internal safety tank following the instruc-
tions in the Section "End of Season operations". At the end,
press again the
button to restore the heating function.
REAL FEEL FUNCTION
(available only from remote control)
REAL FEEL is the innovative De'Longhi
technology that works simultaneously
on temperature reduction and humidity
control, securing best comfort level.
With traditional systems, during working
time, optimal comfort conditions may
be reached but not secured over time.
With REAL FEEL, once optimal comfort
is reached, PAC automatically modulates
compressor action and air flow, to keep it
over time.
HIGH
MEDIUM
LOW
TEMPERATURE
After a pprox. 1 m inute, t he R EAL F EEL s ymbol ( C15) c hanges c olor
when a pproaching t he b est c omfort l evel ( see f ollowing d iagram).
Operating curve
ORANGE LIGHT: Room conditions far
from optimal level.
GREEN LIGHT: Most people feel good
room conditions, near optimal level.
BLUE LIGHT: Best comfort level.
Perfect!
•
The well-being feeling is a subjective condition: for this
reason, different people may judge differently the same
environmental conditions.
•
In particularly severe environmental conditions (large size
of the environment, high temperature or humidity outside,
poor insulation of the room, too many of people or strong
heat load in the room, strong exposure to the sun ...) this
device may not be able to reach the best comfort level.
SELECT THE TEMPERATURE SCALE
OPERATING FROM THE REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES
•
Remove the cover on the rear of the remote control;
•
Insert or replace the batteries with two new R03 " AAA" 1.5V
batteries, inserting them correctly (see the instructions in-
side the battery compartment);
•
Replace the cover.
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment. Do not mix
old and new batteries.
9
The temperature can be displayed in
°C or °F.
To change the temperature unit of
measure touch both the increase/
decrease keys and for about
10 sec.