Tabla de contenido
6159946700_07
Series: B
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
The rotor blades in this tool have a PTFE
content. The normal health and safety
recommendations concerning PTFE must
be observed when handling these rotor
blades.
● Do not smoke.
● Motor components must be washed
with cleaning fluid and not blown clear
with an air line.
● The silencer must be replaced when
dirty, do not clean and re-use.
● Wash hands before commencing any
other activity.
DISASSEMBLY AND REASSEMBLY
INSTRUCTIONS
See page 4.
Indicates direction of dismantling.
Disconnect the machine from the
compressed air supply.
Remove all accessories.
AUTOMATIC SUCTION ON SV.-14 /
SV.P14
If sanding speed is too low, the suction power
can be adjusted to obtain an excellent Speed /
Suction / Power ratio.
With a 2.5 mm hex key, adjust the air supply at
the venturi by tightening or loosening the screw
(614.65).
Never apply pressure on the two
adjustable stops.
MAINTENANCE
SV.(P) : Should the suction system get clogged,
remove the pad and blow in the dust exhaust
pipe.
10 / 36
English
09/2017
Tabla de contenido
