Maintenance And Cleaning - Delabie TEMPOMATIC 3 Manual De Instrucciones

MAINTENANCE AND CLEANING

• Cleaning chrome
Do not use abrasive, chlorine or acid-based cleaning products. Clean with soapy water using a cloth
or a sponge.
• Frost protection
Drain the pipes and operate the mixer several times to drain any remaining water.
MAINTENANCE
• Mixer: regularly check (as often as necessary) the temperature selector and the mixer's two internal
seats on which the mixing key turns. Replace as necessary.
Replacing the solenoid valve:
• Shut-off the hot and cold water supply.
• Deck-mounted models and wall-mounted TEMPOMATIC 4: loosen the screw
a 2.5mm Allen key without removing it totally, and remove the cap
downwards.
• Wall-mounted TEMPOMATIC 3: Loosen the screw
removing it totally, and remove the spout (fig. F).
• Remove the electronic unit
• Using a 17mm socket
solenoid valve (fig. D, F).
• Install the new solenoid valve and carefully tighten, ensuring that the thread is not damaged.
• Reconnect the connector
• Reconnect the water supply and check that the valve opens/closes by activating the electronic cell.
Check that the solenoid valve is watertight inside the mixer body. If there are any leaks, gently tighten
the solenoid valve.
• Replace the electronic unit and the cap.
• Deck-mounted models and wall-mounted TEMPOMATIC 4: Carefully tighten the screw
• Wall-mounted TEMPOMATIC 3 mural: Carefully tighten the screws
TEMPOMATIC 3.
Replacing the 6V Lithium battery:
• Low battery life
the sensor on TEMPOMATIC 4 or on the TEMPOMATIC 3 electronic model, to blink for 15 days.
• Using a 2.5mm Allen key: loosen the screws
remove the cap
• Remove the electronic unit
• Loosen the screw/s
to change the battery, leaving the washer in place.
• Replace the assembly, carefully tightening the screws
Product conforms to current European Directives.
For Douglas Delabie UK market only: Tel. 01491 824449 email: [email protected]
For all other markets: Tel.03.22.60.22.74 email: [email protected]
The most recent version of this installation guide is available on: www.delabie.com
(fig. D, F) and disconnect the connector
(fig. D, F) for TEMPOMATIC 3, and 13mm for TEMPOMATIC 4, unscrew the
(fig. D, F) to the electronic unit without replacing the unit.
(fig. G, H), will prevent the solenoid valve operating and cause the LED, sited on
(fig. G, H) by rotating slightly downwards.
(fig. G, H).
(fig. G, H) (1 screw on the TEMPOMATIC 3, 2 screws on the TEMPOMATIC 4)
After Sales Care and Technical Support:
(fig. F) using a 2.5mm Allen key without
(fig. G, H) without fully removing them and
(fig. G, H) (taking care not to damage the sensor).
(fig. D) using
(fig. D) by rotating slightly
(fig. D, F).
(fig. F) on the wall-mounted
GB
(fig. D).