Steren ALA-MOV Manual Del Usuario

Before using your new Electronic insect killer, please read
Before using your new movement sensor, read the following
this instruction manual to prevent any damage. Put it away
recommendations.
IMPORTANT
Before using your new Electronic insect killer, please read
• When the battery is low, sensitivity and time
this instruction manual to prevent any damage. Put it away
Recovery may vary.
in a safe place for future references.
• If Ding-dong decreases replace the batteries.
• Clean only with a soft, dry cloth.
• Do no try to open the equipment, may cause malfunction and
warranty repeal.
• Do not expose to extreme temperatures or direct sunlight.
• Do not use or store the equipment near wet places. May
cause malfunction or shock hazard.
• Check the battery regularly.
• When the equipment is not to be used for a long time, remove
the batteries.
FEATURES
• Your new STEREN movement sensor/alarm is a totally
electronic device which is useful, practical, easy to install, and
conveniently sized. This product is constructed in high-impact
resistant white plastic. It also has a switch which selects
between the 2 functions this device offers.
• This device has a support which allows you to adjust the
placement and angle of your sensor up to 260°.
• This sensor will sense movement up to 10 m as a maximum.
• This sensor is directional, meaning it will only detect move-
ment in a straight line.
FUNTIONS
1) The first function is that of advisement which is used when the
alarm's switch is set to the CHIME position. In the CHIME
position your alarm will chime twice when it detects movement
inside its range advising you of the movement. This chiming will
repeat itself every time that movement is detected in the alarm's
range.
2) The second function is the alarm function which is used when
the alarm's switch is set to the ALARM position. In the ALARM
position your alarm will emit a typical alarm sound when it detects
movement within its range. This sound will continue until the
alarm's switch is set to the OFF position.
INSTRUCTIONS
1.- Select the place where you wish to install your alarm/sensor.
2.- Separate the mounting piece from the alarm unit (this can be
done easily by just applying a little bit of pressure).
3.- Measure the separation between the holes in the mounting
piece and place screws in the desired area in order to install the
mounting piece. (screws for mounting not included).
4.- Open the battery compartment on the back of the alarm unit
in order to install the included battery (1 x 9V). Install the battery
making sure to respect the polarity. Close the battery
compartment.
5.- Install the mounting piece in the predetermined area and then
set the alarm unit within the mounting unit. Orient the alarm unit in
the direction you wish to monitor. Set the switch on the alarm unit
to the position of the desired function. (Chime or Alarm).
6.-Make sure that the alarm/sensor is working properly.
SPECIFICATIONS
Input: 9 V - - - (1 x battery)
Dimensions: 110 x 68 x 35 mm
Weight: 99.6 g (without battery)
Before using your new Electronic insect killer, please read
Product design and specifications are subject to change
this instruction manual to prevent any damage. Put it away
without previous notice.