Peavey Vypyr VIP Serie Manual De Instrucciones página 23

4 5
pre-gain low
P1 P2
edit mode
tap tempo
11
ampS ENCODEr
3
Turn this knob to select your amp model. Each amp has 3 channels: if the LED is red, you are on the high
gain channel, yellow for medium gain and green for low gain. When you are using an acoustic preset (Item 1,
Bank C) only the acoustic amplifiers will be available. If you are using a bass preset (Item 1, Bank D) only the
bass amplifiers will be available.
TUNER MODE: Press and hold for 2 seconds to enter tuner mode. The LEDs around the Amp encoder will
tell you what note you are tuning. At the same time, the LEDs around the Stompbox encoder (Item 2) will
indicate whether the note is sharp or flat. If the LED is to the right of the 12:00 position you are sharp (Tune
down). If the LED is to the left of the 12:00 position you are flat (tune up). When all of the LEDs around the
Effects encoder come on, you are in tune.
prE GaIN
4
Turn this knob to crank up the gain —think of it as how much distortion you want out of the amplifier. In Edit
mode this knob controls parameter 1 of either the selected Stompbox or Effect.
LOW ENCODEr
5
Low EQ adjustment. In edit mode this knob controls parameter 2 of either the selected Stompbox or Effect.
mID ENCODEr
6
Mid EQ adjustment. In edit mode this knob controls the Feedback of the Delay effect. Feedback is the
number of times the delay repeats.
HIGH ENCODEr
7
High EQ adjustment. In edit mode this knob controls the Level or amount of Delay effect. All the way to the
left is zero and all the way to the right is max.
pOSt GaIN
8
This is the individual preset volume. In edit mode this knob controls the amount of Reverb.
6 7
mid high
delay feedback delay level
VYPYR ®
12
8 9
post-gain
6 7
5
4
3
2
1
0
USB aux in
reverb level
VIP-1
13 14
23
8
9
master
10
volume
11
12
13
phones
15