Bushnell EliteTactical Manual Del Proprietário página 6

REVLIMITER™ (ZERO STOP) STEPS
ILLUMINATION DIAL (Model# ET46305GI only)
To illuminate the G3-i reticle on model# ET46305GI, rotate the Illumination Dial located
on top of the Side Focus adjustment so that a number is lined up with the side focus index
markonthescopebody(highernumbers=brighter,lowernumbers=dimmer).Toturnthe
illumination off, select any dot between the numbers (view reticle to confirm power off).
The illuminated reticle model ships with battery pre-installed, ready to use. To replace the
CR2032 battery (3 volt lithium coin type), unscrew the cap at the top of the Illumination Dial,
ensure the new battery is installed with the positive (+) mark facing out, and screw the cap
back in place. Please recycle the expired lithium battery.
CARING FOR YOUR RIFLESCOPE
Your scope needs very little maintenance. Exterior metal surfaces should be kept clean. A light dusting with a slightly
dampened soft cloth is enough in most cases.
Your new scope features windage and elevation turrets that are completely sealed against water intrusion.
We recommend that lens covers be kept in place when the scope is not being used. Lenses should be inspected regularly
and kept clean at all times. Dust, dirt, and fingerprints that collect on the lens surfaces will severely degrade image quality,
andifleftuncleanforlongperiods,theanti-reflectioncoatingcouldbedamaged.Althoughlenscleaningisnotdifficult,
it does require care and some patience. Following these lens cleaning steps is recommended:
• Start with a lens brush or a small, soft bristle paintbrush. Gently whisk away loose dirt particles.
• Next, use an ear syringe or bulb aspirator (available in most drug stores) to blow remaining dirt or dust from lens
surfaces.
• If further cleaning is needed, use a dry, soft lint-free cloth. Very gently wipe the lens, starting at the center using a
circular motion, then working outward to the edge. • If this has not corrected the problem repeat the process using condensation from your breath.
Allmovingpartsofthescopearepermanentlylubricated.Donottrytolubricatethem.Avoidstoringthescopeinhot
places, such as the passenger compartment of a vehicle on a hot day. The high temperature could adversely affect the
lubricants and sealants. A vehicle's trunk, a gun cabinet or a closet is preferable. Never leave the scope where direct
sunlight can enter either the objective or the eyepiece lens. Damage may result from the concentration (burning glass
effect) of the sun's rays.
6
1
3a
2a
3b
2b
4
Illumination Dial
Index Mark
Battery
Cap
Side Focus
Adjustment