Kneading
Kneading combines a circular motion while moving up and
down the back.
Tapping
Tapping combines a rapid back and forth tapping along the
back while moving up and down the full length of the back.
Kneading +Tapping
Kneading+Tapping combines the circular motion of Kneading
with Tapping while moving up and down the back.
Adjustable Functions in Manual
Massage
These functions are available when one of the Manual
Massage Functions is active. To activate one of these
functions, simply press the desired button while in a manual
massage function. The corresponding LED will illuminate to
confirm your selection.
Spot
A stationary version of 3 of the manual massage functions,
which can be adjusted up and down with the Up/Down
controls. Spot stops the massage in the location in which it
was pressed and focuses the massage action in that place.
Available with: Kneading, Tapping, and Kneading+Tapping.
NOTE: By definition, Rolling, which moves up and down,
is not available in Spot. However, Rolling can be focused
to a specific area with the Partial function. See below.
Partial
A partial range version of all the manual massage functions,
which can be adjusted up and down with the Up/Down
controls. Partial stops the massage action in the location in
which it was pressed and then works approximately a 4"
range up and down.
Available with: Rolling, Kneading, Tapping, and Kneading +Tapping.
14
Up/Down
Available with the Spot and Partial functions, the Up/Down
button adjusts the location of the massage to a specific
position along the back. To move the massage location
up or down, press and hold the respective button until you
have reached the desired location. When you release the
button, the massage location will be set.
Available with: Spot and Partial Massage
Tapping Intensity
Adjusts the intensity of the Tapping functions between
Low (L) and High (H). The LED light indicates the intensity
level. To change the intensity level, simply press the button.
Available with: Tapping and Kneading+Tapping
Width
Adjusts the location of the massage rollers in Rolling and
Tapping with 3 setting options. Width control allows you
to change the position of the massage rollers so that you
can customize the massage. The LED light indicates the
width setting. To adjust the width of the massage rollers,
simply press the button. Repeat until you have reached
the desired setting.
Available with: Rolling and Tapping
Automatic Shut Off
The eLounger has been designed for convenience and
safety. As a special precaution against falling asleep while
using the unit or leaving the unit on while it is still in operation,
we've programmed it to automatically shut off after 20
minutes. This special feature should not be considered as
a substitute for OFF. Always remember to turn your unit off
when not in use.
NOTE: If you do not use the eLounger for a period of
time (for instance, while you are away on vacation) it is
recommended that you turn off the master power
switch and unplug the chair.
15