Using Bluetooth - Wren Sound Systems V5US Guía De Configuración

Using Bluetooth (cont.)
Figure 5
Problem connecting? Visit wrensound.com/support for additional help.
34
To clear the V5US's memory of all
paired devices, press and hold the
Setup button on the rear of your V5US
and, while holding the Setup button,
press the Power button on the front
control panel. The Volume indicator
will blink amber two times to indicate
that the memory has been cleared.
When the V5US is powered on again,
and Bluetooth has been selected as
the source, it will be in pairing mode
and ready to pair with a Bluetooth
device (see "Pairing with your V5US"
on pages 31-32).
Note: Clearing the V5US's memory will
also clear any WiFi connection between
your V5US and your network. To reconnect,
follow the instructions for connecting
solid
your device.
blue
After you have cleared your V5US's
memory, you must delete the Wren speaker
from your source device's list of available
Bluetooth devices before you can pair it
with the V5US again. To delete a previously
paired Wren V5US from your source device's
memory, follow the directions provided by
the manufacturer.
Important note on volume control
when using Bluetooth
As with all Bluetooth pairings with audio devices, the volume control of your
Wren V5US functions as a "master" volume control. That means that, when you
are using Bluetooth, the volume control on the V5US governs how loud your
music can play. Once you have set the volume level on the V5US, the volume
control on your source device allows you to play music ranging from very low
to as high as your V5US "master" volume setting allows. For best results, we
suggest setting the master volume control on the V5US at or near maximum
volume. The best way to determine where to set the volume on the V5US is to
use the following steps:
• Set the volume control on the V5US at about half of maximum.
• Set the volume control on your source device at or just below maximum.
• Play music that you are familiar with.
• Raise the volume control on the V5US in small steps until it is as loud as you
think you will want it to play.
• Turn the volume down on your source device. You will find that it goes from
the peak loudness you established all the way down through medium to
soft to inaudible.
• You can now use your source device to play music from very low to as
loud you have set the V5US to play. This enables you to manage volume
remotely using your source device.
35