Axis Orbit 4000 Manual De Instrucciones página 9

3. Remove loose hairs from inside
head assembly with brush. (fig. 3)
4. Remove loose hairs on cutter
mount. (fig. 4)
5. Remove inner cutter assembly
by turning the center knob counter clockwise and lift out. (fig. 5)
Clean hairs off with brush supplied. To maximize shaving comfort and
closeness, periodically remove the head assembly to determine if your
shaver needs cleaning, particularly if you have a heavy beard and use
the shaver daily. If you routinely check the amount of shaven hairs
under the head and clean the entire head assembly
when necessary, your shaver will always run at peak
performance. After cleaning, replace the inner cutter
assembly back into place.
Axis Orbit 4000 and Orbit 2000 |1| english
3 4
5
Important! Make sure that the center knob is locked into place by
pushing down and turning clockwise.
After cleaning, always replace the plastic head guard
to protect the floating heads.
Trimmer Cleaning
Turn shaver off and open trimmer by pushing the
trimmer button upward.
Using the brush, clean outside and inside of trimmer
after each use.
When finished, close trimmer by sliding trimmer
button down.
Axis Orbit 4000 and Orbit 2000 |1| english