Layout And Items Supplied - EINHELL TE-BD 750 E Manual De Instrucciones Original

Operate the device only within the specifi ed out-
put range. Do not use any low-powered machines
for heavy duty work. Do not use tools to perform
work for which they were not intended.
Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and al-
ways keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool,
prior to maintenance, and when changing the drill
bit.
Pull out the power plug.
Ensure that the mains connection is protected by
at least a 10 A-rated fuse.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the
object you are working on. Never use the machine
when you are not concentrating or are distracted.
Never use the machine when you are under the
infl uence of alcohol or are taking medication.
Check the tool for damage
Before using the tool, safety devices and any
slightly damaged parts must be carefully checked
to ensure that they are in good working order. Vi-
sually examine the tool's power cable on a regular
basis. All parts must be correctly assembled and
meet all the conditions required to ensure proper
operation. Unless otherwise specifi ed in the ope-
rating instructions, any damaged safety devices
and parts must be properly repaired or replaced
by a professionally recognized workshop. Never
use tools with defective On/Off switches.
Warning! Using any plug-in tools and accesso-
ries other than those specifi ed in these operating
instructions can lead to injury.
Now, please read and follow all steps and
procedures included in the operating instruc-
tions.
Anl_SA_TE_BD_750_E_SPK8.indb 23 Anl_SA_TE_BD_750_E_SPK8.indb 23
GB

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Machine base
2. Pillar
3. Roll base
4. Drill table
5. Drill table clamp shaft
6. Machine head
7. V-belt cover
8. Motor
9. Rotary feed handle
10. Drill chuck
11. Spindle
12. Mounting holes
13. Folding chip guard
14. Depth stop
15. Speed control lever
16. Fastening screws for chip guard
17. Digital display
18. ON switch
19. OFF switch
20. On/ Off switch for LED lamp
21. Height adjustment screw for chip guard
22. Stop screw for chip guard
23. Fastening rail for chip guard
24. Taper mandrel
25. Scale ring
26. Socket head screw
27. Crank
28. Locking ring
29. Clamping screw for drill table
30. Clamping screw for drill table support
31. Drill drift
32. Fastening screws
33. Spindle for height adjustment
34. Emergency Stop switch
35. Gear rack
36. Holder for chip guard
37. Locking screw for V-belt cover
38. Drive pulley
39. V-belt
40. Variable pulley
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
- 23 -
27.02.2018 13:46:45 27.02.2018 13:46:45