Stop Input - Key Automation 900CT-380 Manual De Instrucciones

Start input function
This menu allows selecting input operation modes (see paragraph "Activation
inputs"):
StAn Start and Pedestrian Start input standard operation,
according to menu setups.
no Start inputs from terminal board are disabled. Radio inputs
operate in StAn mode.
AP.CH Start impulse always controls the opening phase, Pedestrian
Start always controls the closing phase.
PrES Manned operation; the gate will open as long as the Start
input stays closed and it will close as long as Pedestrian
Start stays closed.
oroL Timer-operation; the gate stays open while the Start input or
Pedestrian Start input is closed; as soon as the contact
opens, the pause count down will start.
Brake function
This menu allows you to active the braking function thanks to which you can
prevent a heavy gate, following a command or a safety intervention, due to
inertia, continuing to move for a few seconds rather than blocking
immediately.
IMPORTANT: if the motor has an automatic electromagnetic brake, this
function must be turned off.

Stop Input

This menu permits to select the functions associated to the
command of STOP .
no The input STOP is not available.
ProS The input STOP stops the gate: pressing the command START
the gate continues the motion.
invE The command STOP stops the gate: at the next START the
gate starts moving in the opposite direction.
The setting of parameter STOP determines also in which direction the gate
will move at the next START, if it has stopped because of an intervention of
the safety edges or the obstacle sensor. If you set no, the START command
restarts the motion in the same direction.
NOTE: during the pause, the STOP command will stop the pause time count,
the next START command will always close the gate.
Photocell 1 input
This menu allows enabling the input for type 1 photocells, that is to say,
photocells active both during the opening and closing phase (see paragraph
"Installation").
no input disabled (ignored by the control unit).
No jumper with the common is required.
AP.CH input enabled.
29