Steren DT-01 Manual De Instrucciones

Before using your new Electronic Clinical Oral Thermometer, read this Before using your new Electronic Clinical Oral Thermometer, read this
instruction manual to avoid any malfunctions. instruction manual to avoid any malfunctions.
• Do not bump the thermometer
• Warranty is void if you try to dissemble the device
• Do not use this device near water sources or humid places
• Do not place the thermometer in the fi re
• Use a soft dry cloth to clean the device, also it is recommendable to use
alcohol to sterilize it
• Do not use solvents
• Do not expose to direct sun light
• Do not open the thermometer, except for battery replacing
1.- LCD screen
2.- On / Off
3.- Sensor
4.- Battery compartment
This Steren product is warranted under normal usage against defects in
workmanship and materials to the original purchaser for one year from the date
of purchase.
1.- This warranty card with all the required information, invoice or purchase
ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of
charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim
was received.
4.- Steren sell parts, components, consumables and accesories to costumer, as
well as warranty service, at any of the addresses mentioned later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling, leaky
batteries, failure to follow enclosed instructions, improper repair by unauthorized
personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase
establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice or
purchase ticket.
RETAILER INFORMATION
Name of the retailer
Address
Product
Brand
Part number
IMPORTANT
CONTROLS
1
3
2
Product: Electronic Clinical Oral Thermometer
Part number: DT-01
Brand: Steren
WARRANTY
CONDITIONS
1.- If the LCD screen looks blur or black, it means you should replace the battery.
2.- Remove the battery compartment cover and pull out the old battery using a
toothpick.
3.- Place the new battery (button type, 1,5V LR41), please check the polarity.
4.- Replace the cover and check the LCD screen.
1.- Before using, disinfect the tip of the sensor with alcohol.
2.- Press the on / off button once, the message 188.8E will display in the screen
and you will hear a beep.
3.- After few seconds, the screen will show "L" and °C, then the thermometer is
ready for use.
4.- Put the tip of the sensor under the tongue, keep your mouth close to
measure the temperature.
5.- Wait for 1 minute to know the current temperature. The result will be
displayed in the screen and the alarm will beep for 4 seconds. Now the process
is complete.
6.- The thermometer will power off after 10 minutes after their use, but we
recommend to power it of manually to save energy.
7.- Keep the thermometer in a safe place inside of their storage after their use.
If the temperature of the environment is higher than 32°C, the thermometer If the temperature of the environment is higher than 32°C, the thermometer
will measure it instead of the body. will measure it instead of the body.
After their fi rst use, when you power on the thermometer, it will display the After their fi rst use, when you power on the thermometer, it will display the
last measurement for 2 seconds. last measurement for 2 seconds.
Input:
Measurement range:
Accuracy:
Screen:
Power consumption:
Battery life:
Dimensions:
Weight:
Alarm:
4
Product design and specifi cations are subject to change without previous Product design and specifi cations are subject to change without previous
notice. notice.
Serial number
Date of delivery
In case your product fails or have any doubt, please contact your
nearest retailer. If you are in Mexico, please give a call to our Call Center.
Call Center
01 800 500 9000
REPLACING THE BATTERY
HOW TO USE
SPECIFICATIONS
1,5V (LR41 button cell battery)
32,0°C to 41,9°C
+/-0,1°C (between 35°C and 39°C)
+/-0,2°C (under 35°C or over 39°C)
3 1/2 digits, LCD screen.
0,15 milli-watts
100 hrs. continuous operation (approx.)
14mm. x 22mm x 19mm
10,5grs.
beeps for 4 seconds when reading is complete