Technical Data; Replacement Parts - Grohe 36 321 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
GB

Technical data

• Flow rate at 3 bar flow pressure without downstream
resistances:
• Running time:
Installation
Plaster and tile the wall, excluding the area of the structural
shell protection.
1. Cut off inspection chamber (A) flush with tiles, see fold-out
page I, Fig. [1].
Flush pipes thoroughly before and after installation
(observe EN 806).
2. Fasten frame (B) using screws (C) and washers (C1),
see Fig. [2].
Connection
1. Insert filter (D) and connect hose (E) to the cold water
isolating valve (E1), see Fig. [3].
2. Insert filter (D) and connect hose (F) to the hot water
isolating valve (F1).
3. Attach hose (G) to outlet connection (G1).
Open hot and cold water supply and check that
connections are watertight.
4. Insert wall plate (H) from above in the frame and fasten
using screw (H1), see Fig. [4].
Operation
By pressing the pushbutton cap, water flow is initiated for the
preset running time. After expiry of the preset time, the valve
stops the flow of water automatically and without kickback.
Setting temperature limiter
1. Remove screw (I) and detach lever (J), see Fig. [5].
2. Remove screw (K) and remove temperature limiter (L).
3. Remove feather key (M) from temperature limiter (L) and
reinsert in the desired position. The grooves in temperature
limiter (L) correspond to the temperatures that can be
selected, see Fig. [6].
Assemble in reverse order.
Setting the running time
1. Close water supply.
2. Push cover ring (O) forwards, see Fig. [7].
3. Unscrew cap (N) with cartridge.
4. Detach cylinder (P) from the cartridge.
approx. 15 l/min
5. The running time is changed by adding or removing insert
7 s / 15 s / 30 s
rings (Q):
yellow + blue insert ring = 7 s
yellow insert ring = 15 s (factory setting)
no insert ring = 30 s
6. Reattach cylinder (P) to the cartridge and refit the cartridge
with cap (N).
Maintenance
Shut off hot and cold water supply.
Inspect and clean all components and replace if necessary.
I. Cartridge, see Figs. [7] and [8].
1. Unscrew cap (N) with cartridge.
2. Detach cylinder (P) from the cartridge and clean or replace.
Assemble in reverse order.
II. Mixer spindle, see Figs. [9] and [10].
1. Loosen screw (H1) and remove wall plate (H).
2. Disassembly of lever (J) is as described in section Setting
temperature limiter, see Fig. [5].
3. Remove screw (R), see Fig. [10].
4. Pull out mixer spindle (S) and replace.
Assemble in reverse order.
Screw (R) must engage in groove (S1) of mixer spindle (S).

Replacement parts

see fold-out page I
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
2
Tabla de contenido
loading

Tabla de contenido