urmet domus IPercom elekta steel 1060/18 Manual Del Usuario página 6

ENGLISH
1 DESCRIPTION
The device Ref. 1060/18 or /19 is an Elekta Steel vandal-proof call module for Ipercom serverless system.
The main features are:
• Signal management using 3.5" graphic colour display and evolved graphic user interface (GUI).
• Simultaneous lock with pulse capacitance discharge (SE+; SE-) and no-voltage contact relay (C-NC-
NO) operation.
• Garage gate lock low current operation (SE2).
• Hall button input.
• Door sensor input.
• Audio repeat device control for use with hearing aid.
• LAN connection with RJ45 connector and Power Over Ethernet (POE).
• Set-up by means of 2 terminals for local power supply.
• 125 kHz integrated transponder key reader (Ref. 1125/50).
• Infrared proximity sensor for user detection.
• CCD colour camera with wide-angle lens.
• Alphanumeric keypad with 18 buttons, three of which multifunctional.
2 INSTALLATION
• Arrange the duct so that it ends in correspondence with the lower hole of the fl ush-mounting box.
• Remove the lower cap from the wire hole (1).
• Apply adhesive labels on the holes for the screws of the frame (2).
• Install fl ush-mounting box at indicated height (3).
• Fix the magnet (tamper) at the indicated height with the two-sided adhesive tape included (4).
• Fix the frame to the fl ush-mounting body (5).
• Make the electric connections.
• Fix the calling module to the frame (5).
A L T
O
T O
P
H A
U T
A
6
1
ALTO
TOP
HAUT
B
2
3
A L T
O
T O
P
H A
U T
DS1060-135