Explanation Of Symbols; Declaration Of Conformity; General Safety Instructions - Silverline 123339 Manual Del Usuario

GB

Explanation of Symbols

• Do not dispose of WEEE (Waste Electrical
and Electronic Equipment) as unsorted waste
• Class II construction (Double insulated)
• Wear gloves
• Wear breathing protection
• Wear eye protection
• Wear hearing protection
Specification
Voltage .................................................230V
Frequency ............................................50Hz
Power ...................................................800W
No load speed ......................................11000RPM
Disc diameter .......................................115mm
Weighted vibration ...............................2.87m/s
Sound pressure ....................................94.1dB(A)
Sound power ........................................105.1dB(A)
Double insulated ..................................
As part of our ongoing product development, specifications
of Silverline products may alter without notice.

Declaration of Conformity

Product number: 123339
115mm Angle Grinder SS 115-800-AG
Description:
Silverline Tools Ltd declares that the above product conforms
to the following directive(s):
93/68/EEC, 98/37/EEC
With reference to:
EN60745-1:2003+A1:2003
EN50144-2-3:2002+A1:2002+A2:2003
EN50144-1:1998+A1:2002+A2:2003
Philip Ellis
Director
Silverline Tools Ltd
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, UK
4

General Safety Instructions

Carefully read and understand this manual and any label before use.
Keep these instructions with the product for future reference. Ensure all
persons who use this product are fully acquainted with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this product, do not attempt to use it.
Keep guards in position
• Always keep guards in position, in good working order, correctly adjusted
and aligned. Never attempt to use a tool if any of the supplied guards are
missing. If any guards are damaged, replace before use.
Remove adjusting keys
• Always check to see that keys and adjusting devices are removed from
the tool before use.
Clean the work area
• Accidents can occur where benches and work areas are cluttered or
dirty, floors must be kept clear, avoid working where the floor is slippery.
If working outdoors, make yourself aware of all potential slip and trip
hazards before using this tool.
Children and pets
• Children and pets should always be kept at a safe distance from your
work area. Lock tools away where children can't get access to them.
Do not allow children, or untrained persons to use this tool.
Use the correct tool
• Do not force, or attempt to use a tool for a purpose it was not
designed for.
Keep your balance
2
• Do not over reach, keep proper footing at all times, do not use tools
when standing on an unstable surface.
Accessories
• The use of any attachment or accessory other than those mentioned
in this manual could result in damage or injury. The use of improper
accessories could be dangerous, and will invalidate your warranty.
Secure work
• Always ensure work is secure, if appropriate use a clamp or vice.
Check for damaged or missing parts
• Before each use, check if any part of the tool is damaged or missing,
check carefully that it will operate properly and perform its intended
function. Check alignment of moving parts for binding. Any guard or
other part that is damaged should be immediately repaired or replaced.
Do not use if defective.