Auto Connection; Pairing And Connecting A Headset - Telefunken TX 100 Bluetooth Serie Instrucciones De Uso

prompts on your mobile phone and your TELEFUNKEN TX 1** to complete the pairing process.
If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.

Auto connection

When a device is successfully paired with the telephone base but not connected, the handset
displays
Mobile setup completed Device not connected and then
Auto-connect function enabled Press OK. You can press MENU/OK to exit. You can also
connect a device manually).
D. Pairing and connecting a headset
Before you begin, make sure that your Bluetooth enabled headset is not connected to any other
Bluetooth device. Refer to your headset User's Manual to learn how to search for or add new
Bluetooth devices.
1. In standby time. Press MENU/OK and choose Bluetooth.
2. Select Add headset.
3. Place Bluetooth headset next to base. Press Menu/OK.
4. If there are already four devices on the paired devices list, the screen displays Maximum
of 4 devices can be paired and prompts you to replace an existing paired device
5. Press MENU/OK. The screen displays Please set your headset to discoverable mode,
then press OK.
6. If a device is already connected to the telephone base, the screen displays Connected
device will be temporarily disconnected. Press MENU/OK to temporarily disconnect the
device and continue the pairing process.
7. Set your headset to discoverable mode (refer to the User's Manual of your headset).
8. Press MENU/OK to search for your headset.
9. Once the telephone base finds your headset, press MENU/OK
10. Enter the PIN of your headset (the PIN for most Bluetooth devices is 0000), then press
MENU/OK.
11. When the handset displays Headset A paired to base. Connect now? Press OK, then
press MENU/OK on the handset.
- When you already have two devices on the active devices list, the handset shows
Maximum of 2 devices can be connected. You are prompted to replace an existing
headset on the active devices list
- When you already have one headset on the active devices list, the handset shows
Only 1 headset can be connected. You are prompted to replace the headset on the
active devices list
10. When a device is successfully connected, the handset displays Headset setup
completed Device connected and the corresponding status icon (Mobile1 or Mobile 2).
Note: The pairing process may take up to one minute. If the pairing process fails, try again.
If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.
Auto connection
When a device is successfully paired with the telephone base but not connected, the handset
displays Headset setup completed Device not connected and then Auto-connect function
enabled Press OK. You can press MENU/OK to exit. You can also connect a device manually.
TX Bluetooth 55