PROFLO PF5414WH Instrucciones De Instalación

Installation Instructions
Wall Hung Lavatory
Care & Maintenance
Do not use abrasive powered or liquid cleaners
which can damage the product surface
Caution: Product is Fragile. To avoid breakage and
possible injury handle with care!
Installing Wall Hung Lavatory
1. Determine the sink position on the wall. If this
is a new installation and there is no support,
remove drywall and mortise a 2"x6" board for
suitable reinforcement behind the finished wall
as shown in Figure 1. Re-Finish the dry wall
and paint as desired. Placement of the wall
hanger support is determined by measuring
to the center line of the hanger to the floor, A
in Figure 1. The Hanger height should be 31"
for typical installations and 34" to meet the
ADA requirements. Note the difference in the
hanger lip and sink height must be taken into
consideration, B in Figure 2.
WALL HUNG LAVATORY
2. Hold the steel hanger, supplied, against the
wall and centered over the waste outlet hole.
Mark two places in the hanger slots with a
pencil. Bore pilot holes into the markings. These
holes will be used for the lag screws that will
hold the hanger, figure 2 in place. Note: Not
all models are supplied with lag bolts, anchor
screws and steel hangers. Various lag bolt sizes
for numerous installations are available to the
installer at most local wholesale stores. Secure
the lavatory hanger to the wall
Figure 1
2 x 6 support
A
Figure 2
© 2013 Wolseley
B
31"
Top of Rim
(Residential)
(34" ADA max.)
3. Install the faucet onto the lavatory per the faucet
manufactures instructions. It is easier to install
it before the lavatory is installed and against the
finished wall.
4. Lift the lavatory on top of the hanger by placing
the rear lip of the lavatory, Figure 4, on the
hanger. Make sure the rear lip is securely
engaged and centered on the hanger.
Figure 4
Lavatory
Waste
5. Lag bolts with washers sized to fit shall be
installed in lavatory anchor holes located on the
back sides of the sink. The anchor bolts must
be installed and tightened snugly to prevent the
lavatory from lifting off the wall,
Hanger
Figure 1
2 x 6 support
A
Figure 2
Water
Supplies
Waste
Finished
Floor
Rear Lip
Steel
Hanger
Anchor Screw
Waste
Hanger
Anchor
Screws
Figure 3
Anchor
Screws
Figure 3. A pilot hole may need to be drilled to
securely anchor the lag bolts. Make sure the
lavatory is leveled before tightening these bolts. DO
NOT OVER TIGHTEN, CHINA WILL BREAK.
6. Connect the drain assembly and trap as well as
the hot and cold water supply lines. Check for
leaks.
0713 16540