Home Decorators Collection 91662 Guía De Uso Y Cuidado página 8

Assembly - Close-To-Ceiling Mount
1
Close-to-Ceiling Mounting
□
Remove the canopy ring (FF) from the canopy (C) by turn-
ing the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (JJ) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting
bracket (A).
□
Remove the decorative canopy bottom cover (L) from the
canppy (C) by depressing the three studs.
JJ
2
Routing the wires
□
Remove three of the six screws and lock washers (KK)(every
other one) securing the motor collar to the top of the fan-
motor assembly (E).
□
Route the wires exiting the top of the fan-motor assembly
(E) through the rubber gasket (CC) aligning the holes in the
rubber gasket (CC) with the three screw holes in the fan-
motor assembly (E).
□
Route the wires exiting the top of the fan-motor assembly
(E) through the canopy ring (FF), and the canopy (C) (make
sure the slot openings for the canopy ring and canopy are on
top). Place the canopy (C) over the collar (M) at the top of the
motor (E).
A
□
Align the mounting holes in the canopy (C) with the screw
holes in the motor (E) and fasten using the three screws and
lock washers (KK) (removed previously). Tighten the mounting
screws securely.
II
C
L
FF
KK
FF
8
KK
M
C
CC
E
C
CC
E