Tabla de contenido
Idiomas disponibles
Idiomas disponibles
wall Installation
tools needed for easy installation: philips head Screwdriver, Drill, 1/8" drill bit, ruler, and a level
•∙For∙installation∙of∙the∙wall∙heater∙you∙will∙need∙the∙following∙parts∙that∙are∙included∙with∙the∙heater:∙2∙anchors∙and∙2∙screws
•∙∙ T he∙location∙must∙be∙situated∙safely∙above∙running∙water∙and∙approximately∙1∙foot∙to∙the∙left∙or∙right∙of∙an∙electrical∙outlet.∙∙For∙safety∙reasons,∙never∙mount∙any∙appliance∙
directly above or below an electrical outlet.
•∙Using∙a∙1/8∙drill∙bit,∙drill∙a∙hole∙1∙½∙"∙deep∙and∙insert∙one∙anchor.∙∙
•∙Measure∙11∙1/8∙"∙from∙the∙center∙of∙the∙installed∙anchor∙mark∙the∙spot∙for∙your∙2nd∙hole.∙∙Use∙a∙Level∙to∙make∙sure∙the∙holes∙are∙the∙same∙height.∙∙∙
•∙Using∙the∙1/8∙drill∙bit,∙drill∙your∙second∙hole∙1∙½∙"∙deep∙on∙your∙mark∙and∙insert∙the∙other∙anchor∙in∙the∙2nd∙hole.∙∙
•∙∙ H ang∙your∙heater∙from∙the∙screws∙by∙lining∙up∙the∙large∙openings∙on∙the∙bottom∙of∙the∙heater∙and∙pushing∙the∙heater∙to∙the∙right∙and∙then∙down∙in∙one∙motion.∙∙The∙heater∙
should now be securely against the wall and is ready to be plugged in.
note:∙If∙the∙top∙of∙the∙heater∙is∙not∙secure∙against∙the∙wall,∙take∙the∙heater∙off∙the∙wall,∙tighten∙the∙screws∙a∙few∙turns∙and∙mount∙it∙again.∙∙
11
Floor
fig. 2
2 fixing holes
/
˝
1
8
hole for fastening
to the wall
Body base
fig. 3
7
hCe-1201
Screw
Wall
fig. 4
hang up
fig. 5
Capítulos
Tabla de contenido
