Message Codes - PCE Stanley TLM 210 Manual De Empleo

Ocultar thumbs Ver también para Stanley TLM 210:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
D
Areas and volumes can be added / subtracted in
GB
exactly the same manner.
F
Area
Press AREA/VOLUME - key {A, 3}. The corresponding
I
symbol {B, 5} appears in the display. The first side to
be measured flashes on the display. Take the two
E
measurements, the result will be displayed in the
P
main line.
NL
Volume
Press AREA/VOLUME - key {A, 3} twice. The corre-
DK
sponding symbol {B, 5} appears in the display. The
first distance to be measured flashes on the display.
S
When 3 measurements have been taken the result
N
will be displayed in the main line.
FIN
HISTORY
Pressing the HISTORY - key {A, 4} shows the last 19
J
displays in reverse order. Using the PLUS - key {A, 2}
and the MINUS - key {A, 7} allows to navigate in the
CN
historical storage.
ROK
In order to leave the history press either CLEAR - key
{A, 5}, ON/MEASURING - key {A, 1} or the AREA/
PL
VOLUME - key {A, 3}. Press and hold the HISTORY -
key {A, 4} until a beep, allows the user to take the
HR
selected result to carry on with calculations.
H
RUS
CZ
Appendix
GR
Appendix

Message Codes

All message codes will be displayed with either "InFo"
or "Error".
The following mistakes can be corrected:
InFo
Cause
204
Calculation error
252
Temperature too
high
253
Temperatur too low Warm up instrument
255
Receiver signal too
weak, measurement
time too long,
distance > 100 m
256
Received signal too
powerful
257
Wrong measure-
ment, ambient
brightness too high
260
Laser beam inter-
rupted
Error
Cause
Hardware error
4
Remedy
Repeat procedure
Cool down instrument
Use target plate
Use target plate
(grey side)
Use target plate
(brown side)
Repeat measurement
Remedy
Switch on/off the
device several times
and check if the
symbol still appears. If
so please call your
dealer for assistance.
Stanley TLM 210 1.0.0 gb

Capítulos

Tabla de contenido
loading

Tabla de contenido