agreto B300 Manual Del Usuario página 5

English
Press the [SELECT] button twice, and CLR.L Y appears on the display.

Now load the scale with a weight known to you or place a known quantity of material into the attachment

unit. The weight should be as large as possible. The device should ideally be completely full.
If tensions occur in the attachment unit and in the scale do not affect the calibration, proceed a little to

the front and back again.
Press the [OK] button, and the current weight flashes on the display.

Press the [OK] button, and the display shows the last calibration weight used.

Change the displayed number to the actual weight or the weight used for calibration. The number can be

changed digit by digit, with the current digit flashing. Use the [SELECT] button to change the current
digit. The leftmost digit becomes active after the rightmost digit. Use the [PRINT] button to change the
number of the current (flashing) digit.
Press the [OK] button, and the display shows S.inP. Calibration is now complete and is confirmed with

three short tones. The weight that you have entered flashes on the display.
Press the [TARE] button to end the calibration function.

To store the settings, press and hold the two left [On/Off] and [ZERO] buttons on the display until the

display restarts.
To stop the calibration process at any point, simply turn off the display.

4 Zero digits
The [ZERO] button is used to reset the zero point of the display.
5 Standard weighing process
Load your device and read the weight.
6 Weighing with the tare function
You can use the tare function to read out the applied quantity for a specific sub-area or lane over a field length
without resetting the scale.
Proceed as follows:
Press [TARE] at the beginning of the sub-area. The weighing display jumps to 0 and displays the NET

symbol.
Continue the journey and the display shows the net weight. This is the weight loss since the activation of

the tare function.
If you want to see the total weight on the scales, you can use the [SELECT] key to toggle between total

weight and net weight.
At the end of the sub-area, take a reading of the net weight and use the [SELECT] button to return to the

display of the total weight.
Repeat this process as often as desired.

7 Switching off
Press and hold the leftmost key until the weighing display goes off.
© AGRETO electronics GmbH 5