Functions And Features - Mestra R-100009 Manual De Instrucciones

English
- Carefully read this manual. It contains important information on safety during the installation,
operation end maintenance of the unit.
- Keep this manual in a suitable place to consult it in the future.
- Check the overall state of the unit just upon unpacking it.
- Before connecting the unit, make sure the voltage shown in the identification plate matches that of
the power source to be used. The installation must fulfil all the applicable safety standards and the
instructions of the manufacturer.
- The manufacturer will not be responsible of the damage caused by an incorrect ground connection.
The damage caused by a faulty installation or usage of the unit will not be covered by the warranty.
- If case of doubt, do not start the unit. Contact a qualified and authorised technician.
- Do not touch the unit or the power cord with wet hands.
- Unplug the unit in case of storm and when you are not going to use it for a long time.
- Place the unit in a dry place, away from dust and water splashes.
- Do not pull, twist or fold the power cord excessively.
- Do not wet the unit; do not use chemical products to clean it
- WARNING: to prevent electric shock hazards, connect the unit to a proper power source (grounded
230 V, 50/60 Hz).
- The machine features a precision circuit. Prevent fortuitous impacts and stresses that could cause
mechanical damage.
- Remove any dirt or water remains from the cord connection.
- Unplug the unit immediately whenever you notice an unusual noise, smell or smoke.
- Do not insert plastic objects into the bowls or any other material that melts at low temperatures.
- Do not use the unit in damp rooms or near inflammable materials (alcohol, solvents,...).
- Do not allow children or non-qualified personnel handling the unit.
- Do not insert metallic rings in your fingers inside the induction cavity.
- Choose a flat and firm surface to place the unit, away from heat or vibration sources.
- Contact the supplier for questions or detailed information about problems with the unit.
INTRODUCTION
The Induction Tool Heater (R-100009) is a simple
desktop device to heat metallic spatulas and similar
tools used for wax modelling in the Dental Lab.
Just insert the head of the tool you want to heat
into the hole at the front of the device, and in a few
seconds it will reach
temperature. This way you don't need to use the
traditional Bunsen burner and you will prevent its
drawbacks: gas tanks, fumes, fire hazard, etc.

FUNCTIONS AND FEATURES

High temperature in a short time.
•
Lower risk of fire and burns.
•
Its two electronic sensors provide a higher
•
energetic efficiency.
the optimal working
GB
Easy to use and ergonomic design.
•
Easy to clean (disposable shield)
•
Safety: whenever the instrument remains
•
inside the hole for a long time, an error sign will
be shown (quick flickering of green and red
lights).
INSTALLATION
• Place the unit in a flat, horizontal and stiff
surface, away from vibration or heat sources.
Make sure there is not any flammable material
nearby.
• Connect the unit to a grounded 230 V, 50/60 Hz
power source.