Idiomas disponibles
Idiomas disponibles
1
2
10mm
3
4
C
Scope of delivery of FMF factory header U6910052
2x header pipes
Scope of delivery of FMF factory header U6910053
2x header pipes
Scope of delivery, FMF factory silencer U6910054
1x FMF 4.1 RCT main silencer with Sparky noise damping insert
1
x
h t
r e
m
l a
p
o r
e t
t c
o i
n
Mounting the factory header
– Remove the standard silencer and shock absorber (see the Owner's Manual).
NOTE:
The shock absorber does not need to be removed entirely. It is su cient to
remove the screws and to carefully place the shock absorber into the link
fork.
- Detach the exhaust springs (1) and remove the standard header.
- Mount the shock absorber (see the Owner's Manual).
- Mount and set up the FMF header pipes and attach them with the exhaust
springs (1) .
Do not tighten screw M8x25 (2) until the entire exhaust system is mounted
without strain.
Ensure that the brake line (3) of the rear master cylinder is not in contact
with the header.The distance between the header and the brake line must
be approx. 10 mm (A). Adjust the brake line if necessary.
A
- Remove the rubber bush of the original main silencer.
- Connect the FMF main silencer with the header and attach using the ori-
ginal screws and bushes (Figure B ).
B
- Set up the complete exhaust system and tighten all xing screws.
If the kick starter is in contact with the header (Figure
tion of the kick starter. If the kick starter is not set farther back, it may damage
the header by striking against it (Figure
- Remove bolt (4) .
- Remove the kick starter, pull it o the shaft, turn it to the rear slightly and
mount it back on the shaft (Figure
D
- Mount the screw (4) (25 Nm, Loctite 243).
f
l i o
D).
C).
7
7
2
0
8
0
1
3
0
5
0
5
D), adjust the posi-
