Arm's Reach Co-Sleeper Manual Del Usuario página 9

WARNING:
!
Failure to follow these warnings and instructions could result in serious injury or death.
Read all instructions before assembly and use of this product.
Converting playard to ®
Arm's Reach CO-SLEEPER
STEP 1
Place foot under lower bar and lift bar up into inverted V position.
Bottom bar must be completely unlocked to unlock top bar.
STEP 2
A. With bottom bar in inverted V shape, place fingers over center of top bar
with thumbs on buttons marked," PRESS TO UNLOCK".
B. Push buttons in while lifting bar slightly to release lock and push down into
U shape.
C. Open 2 front Velcro
plastic corners (receivers).
D. Find locking tab inside both upper plastic corner pieces and push towards
FIG. 1
center of playard.
You may now raise the plastic connector up and out of receiving slot. ( Fig.1)
E. Insert connector into lower slot and push down until locking tab clicks shut.
Repeat same on other side.
F. Pull up on center of top bar until it locks. ( Fig. 2 )
G. Lock bottom bars.
FIG. 2
STEP 3
Assemble and install hangers and floor support rods as shown in figure 3.
Install both hanger and floor support tubes into unit as shown in figure 4.
FIG. 4
®
Bassinet
LIFT UP ON LOWER HORIZONTAL BAR
BEFORE ATTEMPTING TO UNLOCK UPPER BAR!!
flaps on each side of nylon side panel just below
®
9
FIG. 3