Tire Mounting - Denso first time fit Instrucciones De Extracción E Instalación

Installing the TPMS Sensor to the Wheel
1. Ensure that there are no particles on the rubber grommet or around the valve rim hole
area. Do not apply lubricant to grommet.
2. Confirm that the nut tightening tool does not interfere with Rim A1, A2, nut, or the
washer (when provided).
3. Confirm Rim B and TPMS sensor do not interfere.
4. Install the new TPMS sensor as shown in the drawing below. Do not install upside down.
5. Ensure the washer is present on the outer side of the rim hole (when provided).
6. Drive the nut onto the stem using the appropriate size hex for the nut that allows the
nut to fully seat without interference with the stem. Torque nut to manufacturer's
recommended specifications.

TIRE MOUNTING:

1. Set the tire on tire changer after setting rim location so the TPMS sensor is setting in
the location area as shown below.
2. Apply tire lubricant on both sides of the tire bead.
 CAUTION: Prevent lubricating the TPMS sensor.
3. Rotate the rim in the direction as shown and attach the lower bead of the tire to the rim.
4. Rotate the rim in the direction as shown and attach the upper bead of the tire to the
rim.
5. Inflate tire to seat upper and lower beads.
6. Check tire balance and adjust if needed.
 CAUTION: If assembled with TPMS sensor outside this area, contact with the tire bead may
damage the sensor.
TPMS SENSOR
RIM
SENSOR LOCATION AREA
(shaded area)
WASHER
(ensure to install,
when provided)
GROMMET
NUT
TIRE CHANGER MOUNT
RIM
ROTATION
3